Step 1: Site Walkthrough
Before any equipment comes off the truck, we walk the property with you. Identify each surface type (siding material, roof type, concrete vs pavers vs flagstone). Note any pre-existing damage that should not be confused with cleaning damage. Confirm scope: which surfaces are in, which are out. Identify access points for water and power. This walkthrough takes 10-20 minutes and prevents 90 percent of post-job miscommunication.
Step 2: Plant Protection Setup
Before chemistry application: pre-soak all landscaping along surfaces being cleaned. Cover delicate plants (annuals, container plants) with plastic sheeting. Identify drainage paths so we know where rinse water will flow. Lay protection on hardscape edges if needed. Standard 15-30 minutes depending on landscaping density.
Step 3: Surface-Specific Chemistry Application
Different surfaces get different chemistry. Vinyl siding: softwash sodium-hypochlorite-based solution applied through low-pressure pump. Concrete: degreaser pre-treatment for grease zones, mildew chemistry for biological growth. Roof: softwash chemistry, never high-pressure. Each surface gets its appropriate chemistry, applied in the correct sequence (top-down on multi-story buildings to prevent re-staining of cleaned areas below).
Step 4: Dwell + Scrub
Chemistry needs 10-15 minutes of contact time to break biological growth and lift staining. While dwelling, we hand-scrub problem zones (corner buildup, around fixtures, deep pollen accumulation). For commercial concrete, we run the surface-cleaner pass during this window. Hand detail completes the scrub work that automated equipment cannot reach.
Step 5: Low-Pressure Rinse
Final rinse from top to bottom (gravity-friendly, prevents streak-back). Low pressure (under 800 PSI) on siding, higher pressure (3,000+ PSI) on concrete via surface cleaner. Water reclamation if commercial site requires EPA compliance. Final landscaping rinse to dilute any chemistry residue. Total rinse phase: 30-60 minutes for residential, 1-3 hours for commercial.
Step 6: Walkthrough & Sign-Off
Final walkthrough with you (or property manager for commercial). Verify each surface area meets the agreed quality bar. Document any items needing follow-up. Sign-off form completed. Job is not complete until you sign off — if you see something we missed, we go back to it before equipment loads.
Frequently Asked Questions
How long does the typical residential pressure-wash job take?
1,500-2,500 sq ft single-story home, full exterior + driveway + sidewalk: 3-5 hours. 2,500-4,000 sq ft two-story home: 5-7 hours. Half-day or full-day depending on scope.
Do I need to be home during the cleaning?
For initial walkthrough yes. After that, we can work without supervision and call you for the final walkthrough. Most homeowners are home for the first 30 minutes and the last 30 minutes only.
What if I see something missed after you leave?
Call us back — we return at no extra charge to address missed items. Standard warranty on every residential job covers 7 days post-cleaning for any miss or chemistry-related issue.
Do you provide insurance documentation?
Yes. Certificate of Insurance available on request before booking. Workers’ comp + general liability + commercial auto.
Do you serve our area?
60-mile radius from Marshall, TX: Harrison, Gregg, Rusk Counties + Caddo, Bossier Parishes. Confirm: (318) 401-2772.
See the Process for Yourself
Free on-site estimate. Honest pricing, professional crew.